Ignitors

Ignitor Electronic Ignition Ignitor Electronic Ignition

NEVER CHANGE POINTS AGAIN

Over the last 30 + years more than 3,000,000 ignitors have been sold!

Features

  • A solid-state electronic ignition system..."never change points again!"
  • Test Results show the ignitor delivers twice the voltage to the spark plugs, increasing horsepower, fuel economy and plug life
  • A 2:1 improvement over point type systems in current fall time for increased coil output
  • System is designed for use with most point-type coils, optimal performance achieved when used with our Flame-Thrower 40,000 volt coil
  • Electronics are moulded in epoxy, eliminating deterioration from dirt, oil, grease or moisture (better foul weather performance)
  • Fits entirely inside the distributor, no "black box" or wiring to clutter your engine compartment
  • No complicated wiring makes installation easy
  • Compatible with 12-volt negative ground systems (some applications available for 6-volt negative ground and 6 and 12-volt positive ground systems)
  • Works great in stock point-type distributors as a trigger for multi-spark CD ignitions, eliminating the need for expensive aftermarket distributors
Ignitor II Electronic Ignition Ignitor II Electronic Ignition

ALL THE BENEFITS OF THE ORIGINAL IGNITOR AND MORE...

Compared to points, averages 4 times more available energy between 3000 & 5000 RPM

Features

  • The Ignitor II senses current levels in the coil and adjusts the dwell to maintain peak energy throughout the entire RPM range. Dwell angle is increased or decreased with changing engine RPM and operating conditions. This provides more energy at high RPM, reducing misfires while improving engine performance
  • Compared to point-type systems, develops on average 4 times more available energy between 3000 & 5000 RPM, and 2 times more available plug voltage
  • Higher RPM performance is improved when used with the new Flame-Thrower II super low resistance (0.6 ohms) 45,000 volt coil, however, it is compatible with any inductive coil
  • Peak current level is reached just prior to spark, so ignition energy is sustained with less heat build-up, increasing coil and module life
  • Adjusts spark timing over entire RPM range to compensate for the inherent electronic delay, resulting in more stable timing
  • Senses engine startup and will increase dwell time, providing more energy for starting sparks
  • Senses incorrectly wired Ignitor II or a "key left on" condition and shuts down the system protecting the coil and other components from damage
Ignitor III Electronic Ignition Ignitor III Electronic Ignition

IGNITION BOX PERFORMANCE WITHOUT THE "BOX"!

Our Ignitor III ignition modules are designed for the serious performance enthusiast who demands serious power. You've seen the performance increases the Ignitor and Ignitor II series electronic ignitions have brought. Now get ready for more... 5 times more spark energy than points systems. For the maximum Ignitor III benefit, select one of our Flame-Thrower III or HC ignition coils.

Features

  • Multiple Sparks throughout entire RPM range
  • Integrated digital REV limiter with LED feedback for precise RPM setting
  • Memory safe function stores settings eliminating unintended changes to Rev limit
  • Adaptive dwell maintains peak energy throughout the entire RPM range, reducing misfires while improving engine performance
  • Peak current level is reached just prior to spark for maximum energy without heat build-up, increasing coil performance and module reliability
  • Adjusts spark timing at higher RPM's to compensate for the inherent electronic delay
  • Senses startup and increases energy for quicker, easier starting
  • Thermal clad surface mount construction for superior reliability
  • Built-in reverse polarity and over current protection shuts down the system, preventing component damage
  • Not compatible with CD or Multi-Spark boxes

Pertronix Performance Products Europe
Tel/Fax: +44 (0)1276 65554 - Email: info@pertronixeurope.com